Electrolux · Gas, electric & heat pump
Electrolux Dryer Repair Calgary
Electrolux dryers are premium front-loaders with steam features and electronic controls. When one shows an E-code or stops heating, we diagnose it properly and get it running again.
- Same-day visits
- Independent, all-brand techs
- 90-day warranty
Reviewed by Fast Appliance Repair technicians · Updated
Common Electrolux faults
What goes wrong with Electrolux dryers
E-code faults
Electrolux dryers report heater, sensor and motor faults with E-codes. We test the part the code points to rather than guessing.
Steam features not working
Steam models need a water supply. A kinked hose, closed valve or clogged inlet screen stops the steam function.
Long dry times
Restricted vents and dirty sensors are the most common causes.
About the brand
Electrolux in Canadian homes
Electrolux is the Swedish parent of Frigidaire. Electrolux-brand dryers sold in Canada are its premium line, and they share many parts and codes with Frigidaire.
Models we see: Front-load Perfect Steam dryers, stacked pairs, compact and heat-pump models
Call (587) 779-6919Electrolux error codes
Electrolux dryer error codes — what they mean
Codes and wording vary between models and years. Use this as a guide, and tell us exactly what your display shows when you call.
| Code | What it means | Likely cause | Who fixes it |
|---|---|---|---|
| E31 / E32 | Moisture sensor signal out of range. | Dirty sensor, foreign object, or control board. | Technician |
| E42 | Door sensing failure. | Electronic control board. | Technician |
| E52 | Motor stopped or not starting. | Overload, low power, motor or wiring. | Technician |
| E61 | Heater relay failure. | Heater relay stuck or wiring defect. | Technician |
| E63 | Heater shorted to ground. | Heating element or wiring. | Technician |
| E64 | Heater open circuit. | Failed heating element or wiring. | Technician |
| E65 | High-limit thermostat tripped too often. | Restricted vent, bad high-limit or tripped thermal limiter. | Try first |
| E66 | Thermal limiter open circuit. | Tripped thermal limiter or wiring. | Technician |
| E71 / E72 | Outlet thermistor open or shorted. | Failed outlet thermistor or wiring. | Technician |
| E73 / E74 | Inlet thermistor open or shorted. | Failed inlet thermistor or wiring. | Technician |
| EA3 | Supply voltage too low. | Low line voltage or control board. | Try first |
| EA4 | Improper home wiring. | L1-N-L2 wired incorrectly at the terminal block. | Technician |
| EF1 | Vent blocked. | High vent restriction or thermistor fault. | Try first |
| EF3 | Maximum cycle time exceeded. | Blocked exhaust, sensor or control fault. | Try first |
| EF8 | A key is stuck. | Console button or interface board. | Technician |
These codes are from Electrolux's Canadian technician sheet. Many models only show stored codes in diagnostic mode — on those, the technician reads them by holding Cancel and Start together. Frigidaire front-load dryers and Electrolux-built Kenmore (417.) dryers use the same set.
Step-by-step Electrolux code guides
Search every brand
Dryer error code lookup
Moved, inherited or bought a used dryer? Search codes from every brand we repair.
Common searches:
Repairs
What we fix on Electrolux dryers
Dryer Not Heating
The drum turns, the timer counts down, and the clothes come out cold and wet. A dryer that runs but will not heat is th…
Learn moreDryer Not Tumbling
You press start and hear a hum, a click, or nothing at all — and the drum just sits there. Most dryers that will not tu…
Learn moreGas Dryer Repair
Gas dryers are common in Calgary homes, and they fail differently from electric ones. Our licensed technicians test the…
Learn moreElectric Dryer Repair
Electric dryers run on a 240-volt circuit and a large heating coil. When they stop heating, stop tumbling or throw an e…
Learn moreVent & Airflow Service
Lint is the reason most dryers overheat, blow fuses and take forever to dry. When we service a dryer we clean lint out …
Learn moreStacked & Compact Dryers
Condos, townhomes and infills across Calgary often have stacked pairs, one-piece laundry centres, or 24-inch compact an…
Learn moreDryer Error Codes
Look up what the code on your dryer's display means — by brand — and whether you can fix it yourself.
Open lookupFrom our technicians
Electrolux dryer articles
Book online
Book Electrolux dryer repair
Send the basics and we will call you back to confirm a time. In a hurry? Call (587) 779-6919.
FAQ
Electrolux dryer repair — FAQ
Do you repair Electrolux gas and electric dryers?
Yes. We repair Electrolux gas, electric & heat pump dryers across Calgary and nearby towns.
Where is the model number on my Electrolux dryer?
Usually on a sticker inside the door opening or on the back panel. Have it ready when you call — it helps us bring the right parts.
Is my Electrolux dryer worth repairing?
In most cases, yes. Common failures like fuses, heating elements, belts, rollers and sensors cost far less than a new dryer. If yours is not worth fixing, the technician will tell you honestly.
Other brands
We repair every major dryer brand
We repair Electrolux dryers in
Electrolux dryer not working?
Same-day visits across Calgary and nearby towns. Clear quote before any work, 90-day parts and labour warranty.